WARNING: THIS VERSION HAS KNOWN BUGS

OK to Send It, Version 1 (November 2, 2026). It is kept here only so that others can study it or build from it. Do not install it on a car. Use the newest version instead: https://oktosendit.com/ok-to-send-it/

Known bugs so far:
- In the bar setting the boost dial showed gauge pressure (0 at atmosphere), so it read up to 0.99 bar below the unit's own bar display, and was labeled BOOST BAR.
- Vacuum at idle showed as about -10 on the readout, and the needle could run past the end of its scale.
- The peak arc could get a not-a-number (NaN) value on the first samples of a drive; this showed up on 94 rows of a recorded pull. Builders: guard the first samples.
- The status pill said STANDBY while the engine ran.
- The bottom of the dial, the load pod and the oil gauge ran under the unit's own bottom bar.

The NaN count is from a recorded pull. The other bugs were found by comparing the screen with the unit's own code and in the Screen Editor preview, not in a car.

Already installed Version 1, or have a file named ok-to-send-it.zip from before November 3? Replace it with the newest version.

The screen file inside is unchanged from the original download (SHA-256 starts 50d8d6d0792c). The README is unchanged too.
